**Follow
instructions for placement of standard twin bracket before
proceeding**

**There are two ways for us to "V" the
bracket. (1) You can give us the deadrise at the transom or take
the measurements as follows:**

**1: Measure 3" from top of drain hole.**

**2: Measure from keel to the mark 3" above drain
hole.**

**3: Take measurement from 2 and transfer to 3**

**4: This is the side measurement we need (Both sides
will be the same)**

**5: This is the center measurement we need.**

© 1996 D&D Marine Distributors