Drawing out placement of a twin bracket on the transom has two advantages (1)To let you see where this bracket will be placed on your transom. (2) To make sure that the corners of the bottom of bracket will not over hang the bottom of your boat, if they do then the bracket will have to be "V"ed. The following drawings assumes 28"centers on motors, if you decide on 30" centers, adjust to 15" instead of 14". Our standard twin brackets will only take up to 30"centers. Since these brackets are hand welded, all measurements have a tolerance of plus or minus ¼". Mounting measurements can be given the same tolerance but Centerline must be measured true to boat.

twinplace3.bmp (212198 bytes)

twinplace1.bmp

 

BACK

© 1996 D&D Marine Distributors